Call us! (618) 395-3945

Tuesday, May 31, 2016

Build a Book Case w/ Metal Legs

This easy to build bookcase uses 2’ x 4’ sheets of medium density fiberboard (MDF), an inexpensive alternative to plywood, and has fabulous, sleek metal legs. The back of the bookcase in the example was covered with a coordinating wallpaper for a pop of color!

book case plans - D. Lawless Hardware - 34

And the finished product...

book case plans - D. Lawless Hardware -4



Materials:

·         1-1/2” brad nails
·         Wood Glue
·         Satin Nickel Furniture Legs and screws
·         Paint of your choice
·         Wallpaper and glue or Mod Podge, optional

Tools Needed:

·         Table saw or Circular saw
·         Pneumatic brad nailer with compressor
·         Drill with a Phillips bit

Lumber:

·         4 – 2’ x 4’ sheets of ½” MDF (or 1 – 4’ x 8’ sheet cut into fourths)
·         1 – 2’ x 4’ sheet of ¼” plywood

Cut List:

·         2 – ½” MDF at 15” x 48” - Sides
·         8 – ½” MDF at 1-1/2” x 23-1/2” – Front & Back Stretchers
·         4 – ½” MDF at 15” x 24” – Shelves, Top & Bottom
·         1 – ¼” plywood at 24” x 47-1/2” – Back

Step One
Cut the pieces for the sides, and the front and back stretchers. Secure the stretchers using glue and 1-1/2” brad nails as shown in the drawing, locating them ½” back from the front and back edges of the sides. The top stretchers will also be located ½” down from the top of the sides.

book case plans - D. Lawless Hardware 3

book case plans - D. Lawless Hardware 2

Step Two

Cut the pieces for the shelves, top and bottom. Position these pieces on top of the stretchers securing in place with glue and 1-1/2” brad nails.

book case plans - D. Lawless Hardware

Step Three

Cut the piece for the back. If using wallpaper to cover the inside of the back, apply a coat of glue or Mod Podge to one side of the back piece, then smooth the wallpaper in place. Trim away any excess.
Secure the back in place using glue and 1-1/2” brad nails through the back into the sides, shelves, top and bottom.

book case plans - D. Lawless Hardware

Step Four

Finish as desired. I used a few coats of a charcoal grey chalk paint on the example, then used a clear wax over the paint.

Secure a 2x4 block in each corner of the bottom under the lower shelf using glue and 1-1/2” brad nails through the top of the shelf. Position the legs on the blocks, then secure the legs using 1” screws.

metal table legs project

metal table legs

1 comment:

Anonymous said...

great job!